


                          Ztatuz (A TI-86 Status Bar)   

                                  version 0.1
                                17 October 1998


                              (C) 1998 Kirk Meyer
                                kirk@ticalc.org



--- Introduction ---------------------------------------------------------

    Ztatuz is a simple program which puts a status bar at the bottom of
    your TI-86 screen which shows many of the modes that you normally see
    in the mode screen and also lets you change them. To install or remove
    the program, simply run it. When the program is installed, simply use
    the corresponding function key (F1-F5) to toggle the desired parameter.
    The status bar is only displayed when no other menus are displayed.

    There are a few bugs... It is supposed to display at the home screen
    only but I think it might display other places on occassion... For a
    few badly-written assembly programs, using them with the status bar
    turned on will lock the calculator. One such program is Disasm86. Be
    sure to back up your calculator so you don't lose anything important.
    All in all though, I find this VERY useful and worth the slight hassle.


--- The fine print -------------------------------------------------------

    This program is provided to you for your convenience, free of charge.
    I can not and will not be held responsible for any damage or loss this
    product may cause, either directly or indirectly. If my program screws
    anything up, you are on your own. You may not sell this program to
    others for money. It is intended to be freely distributed.
